| It is important to note that the following | | | | otherwise the filter must be REMOVED from the |
| sanitisation process should be carried our | | | | machine to avoid Health and Safety concerns. |
| every 3 months or sooner if there has been | | | | |
| any known contamination of your water cooler | | | |  Turn on the water using your Shut Off |
| or water machine. If your machine or cooler | | | | Valve |
| is left unused or left empty for a length of | | | | |
| time then you should also sanitise the | | | |  If you have a hot machine leave for 5 |
| machine immediately before letting people | | | | minutes to ensure that the hot tank is full |
| dispense water from the machine. | | | | and turn on the red hot switch |
| | | | |
| If your water cooler is connected to the | | | |  Flush half a bucket of water through |
| mains water supply then you must replace your | | | | your taps to remove any remaining Sanitiser |
| filter every 6 months. If your filter is | | | | Fluid |
| older than 6 months then it must be REMOVED | | | | |
| from the machine to avoid Health and Safety | | | |  Taste water to ensure quality |
| concerns. | | | | |
| | | |  Your cooler is now ready to use |
| Why does Water Coolers Ltd use Aqua Dosa | | | | |
| products? | | | | For Bottled Fed Coolers: |
| | | | |
| Aqua Dosa™ are winners of a Green Apple | | | |  Remove the empty bottle from your |
| award for environmentally friendly products | | | | machine |
| this is because the Aqua Dosaâ„¢ solution | | | | |
| breaks down to oxygen and water and leaves no | | | |  Remove the Spike Housing and the |
| toxic products. In addition to this the | | | | separator you will then see the tank |
| product has no taste or odour and kills | | | | |
| bacteria including Legionella, viruses, | | | |  Using your Sanitiser Bottle pour 20ml |
| algae, fungi and fungal spores and is | | | | of Sanitiser Fluid into the tank |
| completely environmentally friendly. | | | | |
| | | |  Leave the machine for 10 minutes |
| For Point Of Use / Plumbed in Coolers: | | | | |
| | | |  While you are waiting clean your |
|  Shut off the water using your Shut | | | | cooler with your Aqua Dosa™ Wipes |
| Off Valve on the inlet pipe | | | | paying attention to the Spike Housing and the |
| | | | separator |
|  Replace your coolers filter with the | | | | |
| Mini Dosa using the push fit connectors. It | | | |  Empty your coolers tank through the |
| is important the filter is REMOVED, as any | | | | taps |
| carbon filter would make the sanitising | | | | |
| solution ineffective. | | | |  If you have a hot machine turn off |
| | | | the red hot switch and then drain the water |
|  Unscrew the see through container at | | | | through your hot tank drain (normally located |
| the base of your Mini Dosa | | | | at the base or back of your machine) |
| | | | |
|  Put 20ml of Sanitiser fluid into the | | | |  Replace the Spike Housing and the |
| container and refit to the Mini Dosa | | | | separator and place a full bottle on the |
| | | | machine |
|  Empty your coolers tank through the | | | | |
| taps | | | |  If you have a hot machine leave for 5 |
| | | | minutes to ensure that the hot tank is full |
|  Turn the water back on using the Shut | | | | and turn on the red hot switch |
| Off Valve | | | | |
| | | |  Leave the machine for 5 minutes to |
|  Leave the machine for 10 minutes | | | | enable the coolers tank to fill up |
| | | | |
|  While you are waiting clean your | | | |  Flush half a bucket of water through |
| cooler with your Aqua Dosaâ„¢ Wipes | | | | your taps to remove any remaining Sanitiser |
| | | | Fluid |
|  Shut off water | | | | |
| | | |  Taste water to ensure quality |
|  Empty your coolers tank through the | | | | |
| taps | | | |  Your cooler is now ready to use |
| | | | |
|  If you have a hot machine turn off | | | | Direct Chill: |
| the red hot switch and then drain the water | | | | |
| through your hot tank drain (normally located | | | | For Direct Chill Systems the procedures |
| at the base or back of your machine) | | | | outlined above remain somewhat valid but we |
| | | | would advise you to contact your supplier for |
|  Replace the filter; if your filter is | | | | more detail. |
| 6 months old then it needs to be replaced, | | | | |