Unclogging a Showerhead

If your shower water pressure is not what itNext, if there is old plumbing tape (Teflon tape)
used to be it could be one of several problems,on the shower pipe, remove it.
however it is most likely a clog in the showerheadWrap new plumbing tape around the pipe and
itself.then screw on the showerhead. Note: When
In the showerhead unit, there is a small filterapplying the Teflon tape, wrap it around the pipe
screen. This filter screen is meant to preventin the same direction that the showerhead will be
small particles of sediment from clogging the tinytightened.
shower holes in the showerhead assembly.Tighten the shower head with a crest wrench
However, if you have noticed the showerheadjust so it is snug.
water pressure has slowly diminished overtime;Turn the shower on and observe if there is a
chances are the filter is clogged.significant improvement in the showerhead water
To unclog the showerhead you first need topressure.
unscrew the shower head from the shower pipe.If you don't see a marked improvement in your
Use a crescent wrench to unscrew the cloggedshowerhead water pressure, you could still have
showerhead.one of several problems. It may be that the
Once you have unscrewed the cloggedshowerhead holes are clogged. If this is the case,
showerhead, you will find a small filter that sitsthen you will need to remove the showerhead
just inside the showerhead. Using either youragain and soak it in a vinegar water mixture to
fingers or a small set of pliers (e.g. Needle Nosedissolve away any build up in the holes.
pliers) remove the filter screen from theIf you notice that your water pressure is low in
showerhead.your entire home then you may have a problem
If you see sediment on the filter screen rinse itwith you well pump or water holding tank. If this
off thoroughly. Then reinsert the filter screenis the case, you will need to call a plumber.
back into the showerhead.