Supercharge Your Water Heater - Add a Hot Water Pump for Faster Hot Water!

Have you ever had to stand shivering in the coldThe Grundfos Comfort System are two such
morning air waiting for hot water with your armsystems, and the Hot Water Lobster is another.
outstretched, fingers extended into the coldThe Hot Water Lobster doesn't have a pump, but
stream of water. It seems to take forever forrelies on the fact that hot water rises, and the
the water to get hot. Speed up your hot waterLobster valve has to be substantially higher than
with a hot water circulating system.the water heater for the system to work.
Traditionally, if you had a hot water circulatingUnfortunately these "tepid water" systems
system, it meant that you had a hot water pipeconsume a lot of energy since you are heating
that ran in a big loop from the outlet of thethat big loop of piping and return line and its
water heater to each fixture one after the other,surroundings. The cost of the energy will far
and then back to the inlet of the water heateroutweigh any monetary savings from water
through a small pump. By continuously pumpingconservation.
water through the loop you have instant hotAnother class of systems that use the cold
water at every fixture.water line as the return line is the "Hot Water
This is very convenient. Hotels and motels haveDemand Systems". These systems only pump
hot water circulating systems; otherwise it couldthe water to the fixture when hot water is
take hours to get hot water with such long pipes"demanded" by the user. The pumping costs are
as they have.small; typically demand systems use less than
However, instant hot water is also very$2.00 per year in electricity costs. This is because
expensive. Not only do you have to pay for thethey run for such a brief time, typically less than 1
energy to run the pump continuously for longminute per use.
periods of time or even full time, but you alsoWhen the user turns on the pump it runs until hot
have to pay for the heat energy being radiatedwater reaches the fixture and then the pump
into the environment from that big loop of hotautomatically shuts off. The cold water line does
water piping. The cost of heating the water isnot end up full of warm water.
considerably more than the cost to run the pump.With the demand system the energy consumed
There are a number of manufacturers producingis no more than if the user just ran the tap as
hot water circulating systems that utilize the coldnormal. Hot water is not being circulated. And
water line as the hot water return line.since the hot water is not being circulated it does
Some of these pumping systems use smallnot affect the life of your tankless water heater
pumps that pump water very slowly, and areor the warranty.
temperature controlled. The pump turns on whenThe water is pumped more quickly than if you
the water temperature drops below a set point,ran the faucet full throttle. You save time, water,
and then shuts off when the water temperatureenergy, and money!
in the pipe reaches another set point. This keepsThere are at least three manufacturers of
the water your entire piping system full ofdemand systems, Metlund, RedyTemp, and
luke-warm water. The water is warmer near theChilipepper. The Chilipepper will run any tankless
water heater and colder the further you get fromwater heater. Some models of the Metlund
the water heater, but it is tepid through out thesystem will run tankless water heaters, and some
piping system.won't, so be sure to inquire before you make a
Most folks don't really want the cold water pipepurchase. The RedyTemp will not work with a
full of warm or tepid water. You don't gettankless water heater.
"Instant Hot Water" as the manufacturers claim. IChoose the type of system that best suits your
think they should be honest and call them "Instantneeds and enjoy the added convenience of quick
Tepid Water Systems". The Lang Auto-Circ andhot water while being kind to the planet.